Mini Ductor Induction Heater Kit For Automotive Flameless Heat 220V EU Plug Hand-held Induction
Mini ductor induction heater Kit For Automotive Flameless Heat 220V Screw Tool
Input Voltage: 220V 50/60Hz
Input Current: 4A
Output Power: 500-900W
Output Voltage: 40V
Output Current: 180A
Size of Packing: 45x35x12cm
— Please be sure to read and understand all safety rules and instructions in this manual before operating the heating inductor.
— Pay particular attention to the safety rules.
— Failure to follow all instructions listed below may result in electric shock, fire, and/or serious personal injury.
1.To prolong your heating inductor, leaving an 10mm air gap between the coil and the work piece is recommended as the insulation of the coil will eventually burn through if held directly to hot material.
2.Choose the appropriately sized coil to give the closest fit to the work piece.
3.Insert both ends of the coil into the coil location socket and tighten the thumb screws securely.
4.Activate the power switch to run the heating inductor for 1-3 minutes until enough heat has been applied to the work piece to break the rust/corrosion bond.
5.Release the power switch to turn off the power.
6.Do not use portable generators. The unstable voltage will damage the unit and void the warranty.
7.Turn unit off and allow the unit and all attachments to cool for at least 20 minutes. Handling the unit or parts before they have cooled may result in injury.
8.Make sure the unit is turned off and unplugged. After cool enough, use a dry, clean, non-abrasive cloth or paper towel to remove grease, oil, and other dirt from the heating inductor and electrical lead before returning them to the storage case. Storage of unit while still hot may result in damage to equipment or pose a fire hazard.
1 X HBR Main
1 X Flexible Soft Coil(1.1m)
1 X 18mm coil(diameter of bore)-(Length 20cm)
1 X 22mm coil(diameter of bore)-(Length 20cm)
1 X 28mm coil(diameter of bore)-(Length 20cm)